Chariot Carriers cx 1 Especificaciones descargar pdf (Pagina 14)

51100967 - B

Uneven Pull – Basic Adjustment

G. Prop up the carrier so that the wheels turn freely.

H. Start with one wheel. Loosen the lock nut on S2 from

the brake caliper. (See image 4)

I. Set the wheel turning very slowly.

J. Unscrew S2 (counter-clockwise) until there is light

braking of the wheel without having to operate the

brake lever.

K. Screw S2 back in for one full turn (clockwise).

L. Tighten the lock nut without moving S2.

M. Proceed in the same way for S3

Uneven Pull – Fine Adjustment

N. If the brakes pull to one side readjust on the side that

the carrier pulls to when the brake is applied

O. After adjustment, check that the parking brake works

properly and that the carrier does not roll away and that

it comes to a stop immediately if it is released.

max 5mm

WARNING

Please note that S1 may only be

unscrewed to a maximum of 5 mm

(3/16“), measured between the tightened

lock nut and screw head. (See image 3)

WARNING

Adjusting screws S2 and S3 must not be

fully unscrewed from the caliper. Make

sure that they extend into the caliper at

least 6 mm / 0.25“.

If this is not the case, there is a risk

that the screw will shear with potential

sudden loss of braking force.

NOTICE

If you cannot obtain satisfactory adjustment,

please consult your Authorized Chariot

Dealer.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Sin comentarios

Chariot Carriers cx 1 Especificaciones Pagina 14